Contralube770 is ideal for all your multi-pin connectors. Ever had a circuit fault/
intermittent problem or annoying ‘gremlins’ in your circuit? Much of the time, just
disconnecting connectors in the circuit and re-seating the connector will cure
the problem. Why is this? Could be the build up of oxides on the contact
surfaces? Could be water ingress, vibration corrosion....the list goes on.
An application of contralube770 is the ideal preventative maintenance solution
- stop these problems before they occur and it causes less headaches and
equipment down time.
You can load up your electrical and non-electrical connectors with contralube and it will not interfere with the current flow or in the case of non-electrical connection, it will not harm or degrade the signal that is going through the connection, e.g. radio waves or digital signals - amazing hey!
How does contralube770 do this? Well take a look at the support PDF - Why Contralube? Facts & Myths About Lubricating Electrical Connectors.
Contralube can be termed ‘dielectric’ which translates to - a material which has negligible electrical or thermal conductivity. Although contralube770 may be physically bridging a gap between two separate pins/circuits it will not allow the current to pass between the pins. Contralube has similar conductive properties to air, so if you do not experience arcing/shorting between pins in unlubricated connectors then the addition of contralube770 should not change the performance/characteristics of the component.
While contralube770 protects you connector, it also helps the assembly of connectors - especially the larger connections. Many connector faults are the result of forcing male and female parts together at incorrect angles, mostly due to the connectors being located in hard to reach places. Contralube770 is effective at reducing the mating force required, ensuring solid connections and efficient assembly.
Multi-pin Connectors & Connections:
